| "ohg...@gmail.com" <ohger1s@gmail.com>: Sep 22 10:25AM -0700 > Hello all-knowing ones..... > Heard a slight "pop" from my TC-P42S30, then went black. Turning it back on yielded a black screen, the red power light blinking 14 times. Tried a couple of fixes mentioned online (removing remote batteries then pressing some remote buttons/holding the power button on the set while pressing one of the "up" buttons/leaving set unplugged for 24 hours) No change other than the red power light is on but no longer blinks.Not really skilled enough to open the back of the set. Any other suggestions or advice would be appreciated. Thanks in advance. 14X on that series of Pannys generally means a blown SN sustain board. What you can try is to take the back cover off and remove and replace every philips head screw on the SN board (left side from behind) making sure they're tight. These screws tended to back out and cause a floating ground issue. Just removing and replacing might get it going. If tightening works (long shot), then I would remove the SN board completely and clean the chassis pan of arcing carbon and replace all the screws. Check the ground pads on the board, they're probably arced as well. I used to flux these and reflow the solder so they ground well to the chassis. I used to rebuild these SN boards in the old days. You'll most likely find shorted mosfets (could be IGBTs, don't recall) and gate driver ICs. These are all surface mount and not easy for an amateur. Best bet if you want to keep it is to buy an SN board from a seller who will guarantee it's actually good. Be careful removing the ribbons from the screen to the board. Tear just one a bit and the TV is junk. |
| You received this digest because you're subscribed to updates for this group. You can change your settings on the group membership page. To unsubscribe from this group and stop receiving emails from it send an email to sci.electronics.repair+unsubscribe@googlegroups.com. |
No Response to "Digest for sci.electronics.repair@googlegroups.com - 1 update in 1 topic"
Post a Comment