- Ampex F4460 reel to reel. - 4 Updates
| captainvideo462009@gmail.com: Dec 16 09:53PM -0800 I'm working on my old Ampex 4460 reel to reel machine. (work is slow), and I'd like to listen to some of my old tapes. I cleaned and lubricated it, demagnetized the heads and put a tape of some familiar music on, and I thought it seemed a bit slow. So I repeated it with other tapes and then followed with an Ampex frequency response alignment tape. The scope was calibrated to 1.0ms off the 1KHZ square wave output and then I looked at the the 1KHZ sine wave off the tape. The period was approximately 1.40ms which appears to translate to 714HZ. Truly hard to believe that it's running that slow, but I don't think that the equipment is lying. So I next got out the Strobeotac and put it on the motor capstan. The motor is rated for 1850 RPM at 115V, and it's running rock solid at 1795. I tried loading it while watching the speed and it remains steady, so it doesn't appear to be a load problem. Could such a slight motor speed reduction cause a 25 percent reduction in the frequency of my 1KHZ test tone off the tape? It doesn't seem possible, but I don't know. The motor has a label that reads that it uses a 3.0UF 330V capacitor. I haven't investigated this yet, but with four wires going into it I figure that the cap must be on the chassis somewhere. I wouldn't think that a cap problem though would cause my RPM's to drop 55RPM would it? Oh and I have no service manual, however I don't think that service manual would do me much good with this problem anyway. If anyone has any thoughts on this I'd sure appreciate hearing them. Thanks, Lenny |
| N_Cook <diverse@tcp.co.uk>: Dec 17 08:16AM > So I next got out the Strobeotac and put it on the motor capstan. The motor is rated for 1850 RPM at 115V, and it's running rock solid at 1795. I tried loading it while watching the speed and it remains steady, so it doesn't appear to be a load problem. Could such a slight motor speed reduction cause a 25 percent reduction in the frequency of my 1KHZ test tone off the tape? It doesn't seem possible, but I don't know. > The motor has a label that reads that it uses a 3.0UF 330V capacitor. I haven't investigated this yet, but with four wires going into it I figure that the cap must be on the chassis somewhere. I wouldn't think that a cap problem though would cause my RPM's to drop 55RPM would it? Oh and I have no service manual, however I don't think that service manual would do me much good with this problem anyway. > If anyone has any thoughts on this I'd sure appreciate hearing them. Thanks, Lenny What gives the speed change? conical/stepped jockey assembly out of registration? |
| N_Cook <diverse@tcp.co.uk>: Dec 17 08:21AM Perhaps a tyre cracked and fallen off , but running against the pulley itself now. |
| "William Sommerwerck" <grizzledgeezer@comcast.net>: Dec 17 05:54AM -0800 The motor is running 3% slow, not 25%. So the problem has to be somewhere between the motor and the capstan. |
| You received this digest because you're subscribed to updates for this group. You can change your settings on the group membership page. To unsubscribe from this group and stop receiving emails from it send an email to sci.electronics.repair+unsubscribe@googlegroups.com. |
No Response to "Digest for sci.electronics.repair@googlegroups.com - 4 updates in 1 topic"
Post a Comment