- Screwdriver bits - 1 Update
| Cursitor Doom <curd@notformail.com>: Mar 07 04:15PM On Fri, 23 Feb 2018 22:42:47 -0500, Tom Del Rosso wrote: > I just twisted a torx bit into a spiral trying to remove a rusted screw, > then used a Dremel to cut a slot across the top and took it out with a > flat screwdriver. The screwdriver didn't bend at all. +1 I had the exact same experience here too; supposedly a premium brand tool in this country 'n' all. Mind you, to be fair, I also had a Snap-On [TM] straight screwdriver bit snap off first time I used it (back in '78) maybe they've improved since. -- This message may be freely reproduced without limit or charge only via the Usenet protocol. Reproduction in whole or part through other protocols, whether for profit or not, is conditional upon a charge of GBP10.00 per reproduction. Publication in this manner via non-Usenet protocols constitutes acceptance of this condition. |
| You received this digest because you're subscribed to updates for this group. You can change your settings on the group membership page. To unsubscribe from this group and stop receiving emails from it send an email to sci.electronics.repair+unsubscribe@googlegroups.com. |
No Response to "Digest for sci.electronics.repair@googlegroups.com - 1 update in 1 topic"
Post a Comment