- Rewiring an antique Torchiere lamp. - 2 Updates
- KDL40V5100 - 1 Update
| David Farber <farberbear.unspam@aol.com>: Jun 23 10:10AM -0700 On 6/23/2021 9:34 AM, Peter W. wrote: > Not everyone has worked around this stuff for nearly 50 years, so it does not come naturally for them. > Peter Wieck > Melrose Park, PA Agreed, "keyless" describes the socket but certainly if you have a keyless socket you need to use a matching keyless insulator, right? Thanks for your reply. -- David Farber Los Osos, CA |
| "Peter W." <peterwieck33@gmail.com>: Jun 23 11:04AM -0700 I need a glove for my right hand. OK.... Purpose? Small, large? Garden, chain-mail? Peter Wieck Melrose Park, PA |
| legg <legg@nospam.magma.ca>: Jun 23 01:06PM -0400 A Sony KDL40V5100 gives lamp error indictions (6 blinks) but the inverter seems to run normally, if burst duration is used for brightness control. Burst periods ~ 4ms which would be acceptible for this kind of backlight. Amplitudes seem well regulated. Service manual pretty uselss without schematics and typical waveforms/voltages. No hints about fault signal tracing. Early start-up messages are normal - just won't enter into a useful standby mode. Any ideas? RL |
| You received this digest because you're subscribed to updates for this group. You can change your settings on the group membership page. To unsubscribe from this group and stop receiving emails from it send an email to sci.electronics.repair+unsubscribe@googlegroups.com. |
No Response to "Digest for sci.electronics.repair@googlegroups.com - 3 updates in 2 topics"
Post a Comment