Digest for sci.electronics.repair@googlegroups.com - 3 updates in 3 topics

8:48 AM Penedão
N_Cook <diverse@tcp.co.uk>: Jan 27 12:49PM

Another eyelet problem with PbF, this time double sided tracks and
contact failure to tracks on component (mainly) side, requires remedial
pin works and resoldering relevant pot pins top and bottom.
Absolutely no original solder wetting of the "blind" side at the pads,
no plate-thru of the pcb ?
N_Cook <diverse@tcp.co.uk>: Jan 27 12:44PM

On 26/01/2017 15:57, N_Cook wrote:
> There are some half-length tanks with send and receive at one end and a
> low-damp suspension at the far end. Surely it would be possible to
> suspend a spiral spring in aero-gel or somesuch
 
solid-state, no boioioioioing
ohger1s@gmail.com: Jan 26 02:35PM -0800

> stages of going bad, but that did not fix the problem.
 
> Has anyone fixed this problem (same model with same issue)?
 
> Thank You in advance, John
 
I'm going to go out on a limb and guess this Panasonic is new to *you*. I remember these unit to be extraordinary. no-painfully slow to boot and non intuitive in operations.
 
This is an early machine that uses a comparatively slow processor and memory, and requires a lot of software to run. Probably normal.
You received this digest because you're subscribed to updates for this group. You can change your settings on the group membership page.
To unsubscribe from this group and stop receiving emails from it send an email to sci.electronics.repair+unsubscribe@googlegroups.com.

No Response to "Digest for sci.electronics.repair@googlegroups.com - 3 updates in 3 topics"

Post a Comment

Subscribe to: Post Comments (Atom)